Manta M4P BIGTREETECH - motherboard for 3D printer

BIGTREETECH's Manta M4P is a powerful 32-bit motherboard with many features. In fact, it offers many upgrade options thanks to many interfaces. The motherboard is compatible with open source Klipper, Raspberry and Marlin software.
When used in combination with BTT CB1, Manta M4P is ideal for 3D printers Voron 2.4, Voron Trident and VzBoT.
In fact, the Manta M4P board has the same connector as Raspberry Pi and can therefore be connected to all versions of Raspberry Pi CM4 and CB1. The easy mounting of the add-on board to Manta M4P can be reinforced by screws. The screws needed to do this are not included in the motherboard supply

Key features:

• 32-bit ARM® Cortex-M0+ STM32G0B0RE, 64 MHz faster and more stable
• BTB connection for all CM4 versions
• 5A for Raspberry Pi - power supply chip TPS5450-5A
• 3 different voltages for fan connectors (5V, 12V and 24V)
• High-performance MOSFETs for better heat dissipation

Possible connections to the BTT Manta M4P board:

• Built-in HDMI connection: with an HDMI cable, you can stream audio and video directly to an HDMI display.
• Filament sensor: a filament sensor can be connected to the Manta M8P board. When the filament runs out, the mechanical sensor alerts the motherboard, which automatically stops printing. After replacing the filament, you can continue printing comfortably.
• BLTouch automatic leveling sensor: there is also an output in the board for connecting a leveling sensor for the platen.
• Connection with an RGB led bar: the Manta M8P motherboard allows you to connect an RGB led bar to customize the aesthetics of your 3D printer.
• SPI touchscreen: a BIGTREETECH SPI touchscreen can be connected to the motherboard.
• DSI Display Port: with a CSI camera you can capture your 3D prints on video.
• Interfaces driver stepper compatible: SPI, UART, STEP/DIR

You can find more information, instructions and firmware here:
https://github.com/bigtreetech/Manta-M4P

Package contains: 1 x BIGTREETECH Manta M4P