Phrozen Resin TR300 Gray (1KG)

TR300 resin from Phrozen has extremely high heat resistance, high mechanical strength and toughness, characteristics that make it ideal for high-temperature applications such as dental thermoforming and industrial models.

It is a material developed specifically for 405-nm LCD 3D printers and takes only 1.3 seconds to cure when printed with a Phrozen Sonic series 3D printer.

Properties

• Viscosity: 160 cps at 250 °C
• Density: 1.1 g/cm3
• Tg (glass transition temperature): 220 °C
• Tensile elongation at break: 2%
• Tear resistance: 32 MPa
• Tensile modulus: 1850 MPa
• Surface hardness: Shore 80D
• Pencil hardness: 5H (at 500 g load)
• IZOD impact resistance: 8 KJ / m2

Instructions for use.

• Clean the model with alcohol spray, do not soak in alcohol for long periods of time.
• Store resins at room temperature and in a dark and ventilated place.
• Shake the resin well before use.
• Already used resins should be stored in a closed, opaque bottle after printing. Avoid mixing already used resins with new ones.
• Resins should always be kept out of the reach of children and out of direct sunlight.
• It is important to wear gloves and a mask during use. In case of direct contact with skin or eyes, wash with water immediately.
• Resin cannot be disposed of directly but must be hardened and then disposed of in plastic.

Package contains: 1 x Phrozen Resin TR300 Gray (1KG)