Python Flex - White - Formfutura

General printing guidelines * Nozzle size: ? 0.25mm Layer height: ? 0.1mm Flow rate: ± 110 - 130% * Print temp: ± 220 - 250° C * Print speed: Medium-Fast Retraction: Yes ± 5mm Heat bed: ± 0 - 60° C Fan speed: 50-100% Experience level: Intermediate *) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting. *) Print temperature depends on printing speed and wall thickness (e.g. ± 220 - 230° C for single wall objects with no infill at 50mm/s and ± 245 - 255° C for high infilled objects at 100mm/s) *) Flow rate depends on configuration of hotend and feeder setup, but is increases when printing speed increases (e.g ± 110% for 50mm/s till even 130% for 100mm/s Filament length ?: 1.16 g/cc 50 gr coil 0.5 Kg spool Ø 1.75mm ± 17.9m ± 179m Ø 2.85mm ± 6.8m ± 68m Hygroscopy Python Flex is a very hygroscopic material and will attract and hold water molecules from the surrounding environment. When opened and exposed to humidity too long this can have a negative effect on the printing behaviour and quality of the filament. It is therefore strongly recommended to immediately remove the spool from the printer after printing and store it in a vacuum bag or airtight container without silica. When the filament is too wet it is recommended to dry Python Flex in an oven or filament drying machine at 65C. Drying time depends on how long the filament has been exposed to humidity. Python Flex is packaged in a vacuum bag with a guaranteed moisture content of less than 0,2% to ensure ideal printing behaviour and results directly after opening the spool. Product export information HS Code: 39169090 Description: Monofilament Country of origin: the Netherlands Compliance * This filament is compliant to below listed directives and regulations. RoHS directive 2011/65/EC REACH directive 1907/2006/EC *) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.