Printing plate machined from aluminum alloy 5083 plates, ground on both faces 8mm thick - milled to size: 255X255 / 305X305 / 355X355 - measurements expressed in millimeters (mm)
CNC ground and milled cast aluminum plate. The design is specially designed for the 3D printers Voron. In particular, it has 4 slotted slots for attachment in the Voron 2.4, and 3 recessed holes for the Voron Trident .
We have revisited the dimensions and tolerances of the holes and slots for a "sturdier" installation that sees the use of low-slotted M4 screws instead of the M3 screws in the original design. Compatibility with the two official Voron models is maintained at 100 percent.
The underside has two M4x0.7 threaded holes for grounding and for attaching the temperature fuse. Here again, we preferred an increased threading compared to the original M3.
The top comes ready to install.
Please note that it is necessary to remove the protective film before it can be used.
A lead time of 48h-72h is expected for stock material.